Homage Forum

wwwEvgeny wrote: ↑September 26th, 2024, 1:43 am

NortON wrote: ↑September 25th, 2024, 1:21 pm 20240925_195953-01.jpeg

Please leave that crown, do not change

.

I like the crown from Athaya better

the dial is 2mm so need to mill down some space in the besel to fit thick besel

Sent from my SM-S9280 using Tapatalk

wwwEvgeny wrote: ↑September 27th, 2024, 5:24 am the dial is 2mm so need to mill down some space in the besel to fit thick besel

Sent from my SM-S9280 using Tapatalk

This is something I recently finished and now I need to give the body a shape

job done, now the dial fit good

Sent from my SM-S9280 using Tapatalk

Just finished.

sazabi2001 wrote: ↑September 30th, 2024, 12:20 am Just finished.

Bravo! It is one of my favorite movements! did you install the pusher buttons yourself too?

@sazabi2001..... lovely, what is that movement ( apart from an Angelus)

A few custom dials I am working on

Sent from my 23090RA98I using Tapatalk

wwwEvgeny wrote: ↑September 30th, 2024, 5:42 am

sazabi2001 wrote: ↑September 30th, 2024, 12:20 am Just finished.

Bravo! It is one of my favorite movements! did you install the pusher buttons yourself too?

No, the case is a 42mm Chinese quartz case comes with 2 buttons, and the stem height just right for this movement. But the buttons location is slightly off, so I had to modify the pin and make a larger cap to get the pin touching the pushers.

It’s a hardened stainless steel case, I have only basic hand tools so it’s very difficult to work on.

geoffdragon wrote: ↑September 30th, 2024, 7:56 am @sazabi2001..... lovely, what is that movement ( apart from an Angelus)

Angelus 215 movement, I think it’s the cheapest in-house chronograph movement from Angelus.