River Steel millemetri modifications

General watch-related discussion
Post Reply
User avatar
Mellons
Chief bottle washer
Chief bottle washer
Posts: 4715
Joined: April 11th, 2018, 6:59 am

MM perv

Microbrand guru

5 year veteran

Frequent Flyer

Moderator

VIP

Prolific poster

HF veteran

Italiano addict

Skillful builder

Good neighbour

Re: River Steel millemetri modifications

Post by Mellons »

Simpsan wrote: ↑January 24th, 2025, 1:13 am You’re welcome, btw the small 7mm rubber washer came… good fit on the OD but I would maybe prefer the ID to be a tiny bit smaller…
IIRC My steel MM used the ‘spray can seal” and I’d say that is a little tighter.

BTW the o rings are I bought from AliX ( cheaper and larger quantity ) arrived before the ones I purchased locally through eBay… go figure!
Difficult to get gaskets to fit spot- one, the ‘spray can’ mod is perfect, cant locate this exact gasket however.
“The problem with the world is that the intelligent people are full of doubts, while the stupid ones are full of confidence”

http://www.homage-forum.com/viewtopic.php?t=27
Top
Post Reply

Return to “General Discussion”