Page 2 of 2
Re: Sterilising a clasp and case back
Posted: April 27th, 2020, 3:38 am
by earloflondon
I'll remove the laser engraved rollie from inside the rehauts of the new rollie cases. I'll use either paper band to cover the inner side of the crystal to protect it from scratches or remove it and sand the engraving. That'll be fun, I guess
I remove the engravings from the buckles just by sanding
Re: Sterilising a clasp and case back
Posted: April 27th, 2020, 3:54 am
by Mellons
Nos cases on the bay....
Re: Sterilising a clasp and case back
Posted: April 27th, 2020, 4:01 am
by Tanukjaju
Okay, wait. I just realized you said Si14....
So this is gen. Why are you trying to sterilize this?
Re: Sterilising a clasp and case back
Posted: April 27th, 2020, 4:38 am
by big eebee
Good old fashioned wet and dry and elbow grease
Re: Sterilising a clasp and case back
Posted: April 27th, 2020, 4:47 am
by big eebee
Re: Sterilising a clasp and case back
Posted: April 27th, 2020, 4:50 am
by djolemag
Yoda wrote:big eebee wrote: ↑April 27th, 2020, 4:38 am
Good old fashioned wet and dry and elbow grease
I hate working on stainless steel cases
Post a picture, let's see how deep it is...
Sent from my ELE-L29 using Tapatalk
