Page 1 of 1
Universal Geneve Super Compressor Homage
Posted: July 1st, 2024, 7:05 am
by Ace0nBase
Hey Gents,
I was looking to try to build a homage of the Universal Geneve Polerouter Sub below. The case is a 42mm super compressor case. Has anyone seen any cases that would be a good donor? I have only had luck finding either 39mm cases or 45mm cases.
Re: Universal Geneve Super Compressor Homage
Posted: July 1st, 2024, 10:52 am
by Mellons
Was the landeron set on ebay a while back 42mm?
Re: Universal Geneve Super Compressor Homage
Posted: July 1st, 2024, 12:48 pm
by toofsy
Re: Universal Geneve Super Compressor Homage
Posted: July 1st, 2024, 2:51 pm
by Hypnogagia
The Spinnaker Bradner might be an option, 42mm.
Re: Universal Geneve Super Compressor Homage
Posted: July 1st, 2024, 3:37 pm
by Mellons
Re: Universal Geneve Super Compressor Homage
Posted: July 5th, 2024, 7:47 am
by Ace0nBase
Thanks everyone for the different suggestions! I have been looking through each of them to try and decide on which would be the best candidate. All will take a little bit of case reshaping but that isnt too big of a deal.