Homage Forum

With you skills and experience it didnt have a choice but to work ,Master Yoda!

toofsy wrote: ↑April 8th, 2020, 10:42 am Almost finished this green croco...but no watch to match with it...20/18mm.
it' maybe the time to order a small bronze watch

IMG_20200408_172846.jpgIMG_20200408_172829.jpgIMG_20200408_172820.jpg

Looks very professional!

Maybe I should wear it without bezel

So pure without bezel!!!!

Nahh I like the bezel!

Emilio wrote: ↑April 8th, 2020, 1:06 pm Maybe I should wear it without bezel

Two words for you:

“plexi bezel”

[mention]Tanukjaju[/mention] I'm still waiting for the 6152/1 plexi bezel to materialize. One step at a time

Yoda wrote:

Emilio wrote: ↑April 8th, 2020, 1:06 pm Maybe I should wear it without bezel

Looks good!

+1, this does looks good to me!

Sent from my SM-N960F using Tapatalk

Aged a set of river hands and made up some fluffy lume to match the dow dial, also added some lead gaskets and sealed the plexi with hypo cement, soldered the crown tube from the inside and greased the crown and tube gaskets,
I'll have to wait until lockdown is over to have it pressure tested but the same thing has worked out well on the other 3646 builds that I did this on

Sent from my LYA-L09 using Tapatalk

Alhig72 wrote: ↑April 10th, 2020, 10:12 am Aged a set of river hands and made up some fluffy lume to match the dow dial, also added some lead gaskets and sealed the plexi with hypo cement, soldered the crown tube from the inside and greased the crown and tube gaskets,
I'll have to wait until lockdown is over to have it pressure tested but the same thing has worked out well on the other 3646 builds that I did this on

Sent from my LYA-L09 using Tapatalk

Nice touch with the lead gaskets I tried to do that with a 3646 I once had, but could only get one of the gaskets on. The movement holder was a few threads short of allowing me to install both.

Please let us know how the pressure test goes