Homage Forum

Good job then again ,because they look deep enough close to gen !

Alou wrote: ↑February 24th, 2020, 5:04 pm Good job then again ,because they look deep enough close to gen !

Yeah, I could show you the ones that I had to discard because some people don't understand "make the engravings 0.2mm deep please"
Luckily, the engravings are done before I spend 4 hours shaping the buckles...

Dont worry keep the good work going ,soon you will perfect them even better!

straps68 wrote: ↑February 21st, 2020, 5:14 am No logo 24mm pre-v

Damn!

Thew dlc buckles are black or gray looking ?Cant really tell from the pic.

Alou wrote: ↑May 9th, 2020, 6:02 pm Thew dlc buckles are black or gray looking ?Cant really tell from the pic.

They are dark gray / charcoal.

Alou wrote: ↑May 9th, 2020, 6:02 pm Thew dlc buckles are black or gray looking ?Cant really tell from the pic.

I think the [mention]straps68[/mention]'s dlc buckes are great! I had a strap made for a 202a case with this buckle. I am really happy I made the purchase. It improved the whole watch for me.

Don’t know about dlc, I don’t have any, but I’ve a brushed buckle and it’s great

Thanks for the reply,can you also do black ?

Alou wrote: ↑May 10th, 2020, 3:02 pm Thanks for the reply,can you also do black ?

Short answer: no, I can't.

Long answer: the place where the buckles were DLC coated said yes and the buckles are not actually black. A guy told me that it is because the steel is bead blasted... I don't believe him. I was unable to find another source.