Homage Forum

deneverember wrote: ↑February 29th, 2020, 4:01 am On this Omega movement.

Faint-discrete lumed custom dial, ss steel case + sapphire.
Some final stem length refinement and ready.

tafari wrote: ↑February 29th, 2020, 8:08 am

NortON wrote:

tafari wrote: ↑February 29th, 2020, 6:15 am fitting the movement ring on a 6152
[/IMG]

Nice dial! This is a new NW case from Gordon?

no, this is a reshaped by me old NW/Jackson case. the dial is a new NW dial. the engraving Gordon did amazing. tomorrow I plan to fill it with resin

NortON wrote:

tafari wrote: ↑February 29th, 2020, 8:08 am

NortON wrote:
Nice dial! This is a new NW case from Gordon?

no, this is a reshaped by me old NW/Jackson case. the dial is a new NW dial. the engraving Gordon did amazing. tomorrow I plan to fill it with resin

I did resin yesterday.
Gordon's new dials perfect. I also want one such

20200229_161330.jpg

tafari wrote: ↑February 29th, 2020, 8:31 am

NortON wrote:

tafari wrote: ↑February 29th, 2020, 8:08 am
no, this is a reshaped by me old NW/Jackson case. the dial is a new NW dial. the engraving Gordon did amazing. tomorrow I plan to fill it with resin

I did resin yesterday.
Gordon's new dials perfect. I also want one such
20200229_161330.jpg

great resining

Tanukjaju wrote: ↑February 29th, 2020, 8:15 am What case is this?

deneverember wrote: ↑February 29th, 2020, 9:38 am

Tanukjaju wrote: ↑February 29th, 2020, 8:15 am What case is this?

Bought a few a while ago. 3 piece ss steel case with 6 screwes in the back.
Same as the ones around the IWC73 and UN I posted lately.
For this Omega ( Unitas with a non-usual balance ) it was an easy fit.
For the Ulysse Nardin and the IWC 73 it needed some work on the lathe though.

But nothing difficult compared to when I built a Jaeger-LeCoultre 467/2 into a 43mm ss case.
Now that was a real pain in the ass.