Homage Forum

neckyzips wrote: ↑April 20th, 2018, 8:02 am After making a couple prototypes, I have the hang of making these enough to produce a run of them.
Several points:
They will only work with night watch's bezel assembly for now
In order to speed the process and make sure orders are filled correctly I need the crystal from you that comes with the bezel. This ensures a couple of things, mostly proper fit.

The bezels will be as an exact copy of the original as I can make them, they will stay on the watch and click at 5 min intervals. While making tiny spring indents is very difficult these will be fitted with aluminum pins that serve the same function, they will function very close and can be tightened up when needed, and are not used to hold the bezel on.
the 12 O'clock dot will be one of two options, a lume filled mostly flat index or a raised plexi cup then filled with lume.
im working on picking up a cnc mill to make these a bit faster, making them one at a time is very consuming, and costing 200+
making them in production where i can leave the machines set up to do each step should bring the price down to 125-150 each.

civic4982 wrote: ↑September 9th, 2021, 2:51 am Bump from April 2018

neckyzips wrote: ↑April 20th, 2018, 8:02 am After making a couple prototypes, I have the hang of making these enough to produce a run of them.
Several points:
They will only work with night watch's bezel assembly for now
In order to speed the process and make sure orders are filled correctly I need the crystal from you that comes with the bezel. This ensures a couple of things, mostly proper fit.

The bezels will be as an exact copy of the original as I can make them, they will stay on the watch and click at 5 min intervals. While making tiny spring indents is very difficult these will be fitted with aluminum pins that serve the same function, they will function very close and can be tightened up when needed, and are not used to hold the bezel on.
the 12 O'clock dot will be one of two options, a lume filled mostly flat index or a raised plexi cup then filled with lume.
im working on picking up a cnc mill to make these a bit faster, making them one at a time is very consuming, and costing 200+
making them in production where i can leave the machines set up to do each step should bring the price down to 125-150 each.