Page 432 of 533
Re: What are you working on now?
Posted: October 11th, 2023, 7:43 pm
by Madantique
I use Glue to fix coin edge ring on dial
Re: What are you working on now?
Posted: October 12th, 2023, 2:50 am
by wwwEvgeny
Madantique wrote:I use Glue to fix coin edge ring on dial
thank you very much for sharing ! very creative shot.
Sent from my SM-S9080 using Tapatalk
Re: What are you working on now?
Posted: October 12th, 2023, 11:09 am
by dj57
Re: What are you working on now?
Posted: October 13th, 2023, 4:35 am
by Alhig72
Going to have a bash at building a 6350 like the last picture
Sent from my SM-F721B using Tapatalk
Re: What are you working on now?
Posted: October 13th, 2023, 6:27 am
by Belkin12
Re: What are you working on now?
Posted: October 13th, 2023, 10:06 am
by dj57
Re: What are you working on now?
Posted: October 14th, 2023, 2:18 pm
by Alhig72
The raffles case turned out OK after a bit of work, used mercedes hands for now while I wait for some pencil hands
Sent from my SM-F721B using Tapatalk
Re: What are you working on now?
Posted: October 15th, 2023, 3:32 pm
by Hypnogagia
Lookin good @Alhig72! In the past I’ve been all about pocket watch conversions and big cases, but these little 36mm oysters are a lot of fun to build and I think I’m getting hooked on them a bit. The solid end-link bracelets with glide lock clasps look great on them, just need to file the holes for the end link pin (takes a couple hours by hand with a diamond file), or an easier route is swapping out the stock clasp on a Raffles bracelet with the glide lock.
Re: What are you working on now?
Posted: October 16th, 2023, 6:19 pm
by Alhig72
Hypnogagia wrote:Lookin good [mention]Alhig72[/mention]! In the past I’ve been all about pocket watch conversions and big cases, but these little 36mm oysters are a lot of fun to build and I think I’m getting hooked on them a bit. The solid end-link bracelets with glide lock clasps look great on them, just need to file the holes for the end link pin (takes a couple hours by hand with a diamond file), or an easier route is swapping out the stock clasp on a Raffles bracelet with the glide lock.
Thanks,just finished it off today with the hands I was waiting for,looks about how I want it now
Sent from my SM-F721B using Tapatalk
Re: What are you working on now?
Posted: October 17th, 2023, 2:48 am
by maracas
Resize_20231017_094327_7484.jpg
Resize_20231017_094327_7142.jpg
Resize_20231017_094327_7696.jpg
