Homage Forum

djolemag wrote: ↑November 6th, 2019, 4:34 pm

Yoda wrote:

djolemag wrote: ↑November 6th, 2019, 4:09 pm Me too, regulator in middle is ideal..but sometimes hard to accomplish, especially if we speak about breguet hairspring. I didn't madtered that overcoil tuning, at least not yet

Sent from my LG-D855 using Tapatalk

Good job anyway!

Thanks mate! You helped me a lot with one missing part, remember

Sent from my LG-D855 using Tapatalk

I remember and you deserved it, well done!

Working on a small ladies’ watch...





Sent from my iPhone using Tapatalk

djolemag wrote:Just finished one Hammy pilot 917 for a friend..

Sent from my LG-D855 using Tapatalk

looks very nice and te movement is very beauty

Now checking some Molnia 3603 (shock resist) movement...just fixed hairspring, movement should be serviced in days to come...not bad so far


Sent from my LG-D855 using Tapatalk

djolemag wrote: ↑November 8th, 2019, 3:03 pm Now checking some Molnia 3603 (shock resist) movement...just fixed hairspring, movement should be serviced in days to come...not bad so far


Sent from my LG-D855 using Tapatalk

Looks promising!

Yoda wrote:

djolemag wrote: ↑November 8th, 2019, 3:03 pm Now checking some Molnia 3603 (shock resist) movement...just fixed hairspring, movement should be serviced in days to come...not bad so far


Sent from my LG-D855 using Tapatalk

Looks promising!

Yes...there are some dots below line, probably of dirt inside has to be cleaned in details. Also, this picture is taken immediately after winding, so line has tendence of going down, probably caused by mainspring...will see next week. I had lot of various obligations this week... Like this:
Setting new server room at my primary job...few more racks to come...


Sent from my LG-D855 using Tapatalk

djolemag wrote:Now checking some Molnia 3603 (shock resist) movement...just fixed hairspring, movement should be serviced in days to come...not bad so far


Sent from my LG-D855 using Tapatalk

wiil be well after service I also checked my cor616 again and find out that I still have to adjust the hairspring well. if I look well the hairspring touch the adjuster. work for the weekend.
thanks again for the tip

tafari wrote:

djolemag wrote:Now checking some Molnia 3603 (shock resist) movement...just fixed hairspring, movement should be serviced in days to come...not bad so far


Sent from my LG-D855 using Tapatalk

wiil be well after service I also checked my cor616 again and find out that I still have to adjust the hairspring well. if I look well the hairspring touch the adjuster. work for the weekend.
thanks again for the tip

Great, glad you solved it! I had few excellent examples how an old movement can work..so when I notice dots out of main line, I am always suspicios about hairspring touching somewhere or pallet fork is dirty...

Sent from my LG-D855 using Tapatalk

Yesterday, some relax at bigger equipment
Trying to finish new spindle for my new drill press..working at my friend's workshop

Sent from my LG-D855 using Tapatalk

Spindle in progress so far

Sent from my LG-D855 using Tapatalk