Page 3 of 3
Re: River Steel millemetri modifications
Posted: January 24th, 2025, 12:50 pm
by Mellons
Simpsan wrote: ↑January 24th, 2025, 1:13 am
You’re welcome, btw the small 7mm rubber washer came… good fit on the OD but I would maybe prefer the ID to be a tiny bit smaller…
IIRC My steel MM used the ‘spray can seal” and I’d say that is a little tighter.
BTW the o rings are I bought from AliX ( cheaper and larger quantity ) arrived before the ones I purchased locally through eBay… go figure!
Difficult to get gaskets to fit spot- one, the ‘spray can’ mod is perfect, cant locate this exact gasket however.
Re: River Steel millemetri modifications
Posted: May 11th, 2025, 5:27 pm
by Mellons
From the archive: Stock steel millemetri with aluminium case back (and stock plexi). Not too far off a ti case set weight here (from memory esdee v2 titanium case set approx 111g head only with plexi)
Re: River Steel millemetri modifications
Posted: May 11th, 2025, 5:30 pm
by Mellons
Stock river steel caseback
Esdee titanium caseback
Aftermarket Aluminium millemetri caseback
The aluminium caseback is the No 1 modification for wearability you can do to any of the cases, especially the bronze.
@Kp0y is now making aluminium casebacks for millemetri cases.
Re: River Steel millemetri modifications
Posted: May 12th, 2025, 5:18 am
by Kp0y
Here are some pictures
Aluminium and bronze
Any engravings can be added
Re: River Steel millemetri modifications
Posted: May 12th, 2025, 8:20 am
by NortON
Kp0y wrote: ↑May 12th, 2025, 5:18 am
Here are some pictures
Aluminium and bronze
Any engravings can be added
WOW! Great work!
Re: River Steel millemetri modifications
Posted: May 13th, 2025, 8:22 am
by heini
You have PM, Axel !
Louis
