Page 14 of 525
Re: What are you working on now?
Posted: August 16th, 2019, 8:29 pm
by speer999
Alhig72 wrote:speer999 wrote:
That plexi!
Hot n cold treatment?
Acetone fumes then pressing down on it, done while fitted to the bezel because the first one I did broke while pressing into the bezel,
Nice one. Thanks.
Re: What are you working on now?
Posted: August 17th, 2019, 11:28 am
by Nottingham
image.jpeg
My 202 project
Re: What are you working on now?
Posted: August 17th, 2019, 11:40 am
by Mellons
What are ingredients?
Re: What are you working on now?
Posted: August 17th, 2019, 3:01 pm
by Nottingham
Dsn complète watch That i will upgrade To swiss 6497 and i hope a better dial from one of the Pre-v masters
Re: What are you working on now?
Posted: August 17th, 2019, 3:02 pm
by Nottingham
But Dsn 202 is a good start. The cg doesnt perfectly fit the case but i saw pics of gen 202 with the same flaw
Re: What are you working on now?
Posted: August 18th, 2019, 4:01 am
by Alhig72
Re: What are you working on now?
Posted: August 18th, 2019, 6:11 am
by Alhig72
Re: What are you working on now?
Posted: August 27th, 2019, 1:52 pm
by Yoda
Getting closer to building a SF240 SW incabloc from scratch with NOS parts, aiming at starting next week, in between a minor surgery, radiation and possibly chemo therapy. Should be possible, time will tell.
Re: What are you working on now?
Posted: August 28th, 2019, 4:52 am
by Yoda
Nothing advanced, serviced a 1946 Junghans and made a new knurled nut for the minute hand, added some patina to the edge to make it look as it has always been there.
20190828_105058_resized.jpg
Re: What are you working on now?
Posted: August 28th, 2019, 12:31 pm
by Emilio
Is that a wall clock?
