Homage Forum

Yoda wrote:High dome crystal required! LOL!

Oh... completely forgot about a crystal.. )

Yoda wrote: ↑August 8th, 2019, 8:15 am High dome crystal required! LOL!

Or use the existing one and drill an opening for the seconds hand to move freely

In the pipeline- just trying to get the ideal hand size for dial

Just done- ross dial painted and lumed by dave (thanks you both).ive had dial for some time just needed to decide on how to make it ‘pop’

Stock steel mm case with small mods- rounded cg pin, bevel added to crown teeth top and bottom, crown gasket mod to achieve 1000m wr, red gaskets front and back, back from cleaning and regulating movement.

Been a while since I had a steel mm- looking forward to it!

Making some buckles

mellons wrote:Just done- ross dial painted and lumed by dave (thanks you both).ive had dial for some time just needed to decide on how to make it ‘pop’

Stock steel mm case with small mods- rounded cg pin, bevel added to crown teeth top and bottom, crown gasket mod to achieve 1000m wr, red gaskets front and back, back from cleaning and regulating movement.

Been a while since I had a steel mm- looking forward to it!

nice dial and the watch too.

mellons wrote:In the pipeline- just trying to get the ideal hand size for dial

please let me know these DSN hands are them for eta2824 and where to get them?

Dsn unfortunately no longer stocks these.. back to drawing board

that is pity

Belkin12 wrote: ↑August 8th, 2019, 8:12 am A long tube second hand for multi layer sandwich dial )

dial is 10mm thick .