Page 2 of 2
Re: Troy Dials- original cost?
Posted: June 6th, 2020, 5:13 am
by Emilio
binbin wrote: ↑June 6th, 2020, 4:06 am
Ok, That accounts for one of the RP closed loop dials. I'm guessing each name is for only one dial.
That spreadsheet makes you realize how few of these dials are actually out there.
Thank you.
I'm still looking at photos trying to figure out how this RP Closed dial is going to be finished. I should start a thread and see who comes up with the best look.
Do it!
That's an early incomplete list, I reckon. There was another one later on

Re: Troy Dials- original cost?
Posted: June 7th, 2020, 1:18 am
by redmill
Thank you Emilio and binbin for posting the info in this thread!
I was just looking at my 2 Tr0y dials and was curious about how I got them.
Re: Troy Dials- original cost?
Posted: June 7th, 2020, 9:35 am
by wwwEvgeny
Sorry to intervene )) what is special about them, any picture? Are they super similar with originals?
Sent from my iPad using Tapatalk
Re: Troy Dials- original cost?
Posted: June 7th, 2020, 6:03 pm
by hako
They have their very own story.
Tr0y started out to create the perfect Rad and 2533 dials with the latest CNC Technology.
An amazing amount of the forum’s knowledge went into these dials and they were produced which much effort on the manufacturer side but also with a lot of technical and machine support by some forum members.
They are three piece dials with a plexi insert. Not easy to assemble due to very tight tolerances that were chosen to avoid gaps between top dial indices and the plexi. The metal parts were made from Aluminum and the top dial was blasted and anodized.
Here two of my builds with them:

Re: Troy Dials- original cost?
Posted: June 7th, 2020, 10:25 pm
by wwwEvgeny
@hako Thank you very much! Very beautiful, are they available ? or only on a second market?
Re: Troy Dials- original cost?
Posted: June 7th, 2020, 11:29 pm
by redmill
I believe there was only one production in 2016, around 100 made like seen in the spreadsheet posted on previous page.
I have one for sale in the parts section currently
Re: Troy Dials- original cost?
Posted: June 8th, 2020, 12:34 am
by wwwEvgeny
redmill wrote: ↑June 7th, 2020, 11:29 pm
I believe there was only one production in 2016, around 100 made like seen in the spreadsheet posted on previous page.
I have one for sale in the parts section currently
Please hold for me No. 5 estimate shipment to Hong kong
Re: Troy Dials- original cost?
Posted: June 8th, 2020, 12:37 am
by wwwEvgeny
If lost no complain, but please send with insurance