Page 2 of 2
Re: Just joined the ranks here
Posted: April 26th, 2018, 4:20 pm
by straps68
You can post pictures of replicas. However, in sales posts that the logos have to be obscured. That's an interesting bracelet on the Glycine!
Re: Just joined the ranks here
Posted: April 26th, 2018, 6:48 pm
by PJerome
Hi, I think I know you from another forum. Either you sold me something or I sold you something.
Re: Just joined the ranks here
Posted: April 26th, 2018, 6:55 pm
by PJerome
That bracelet is called The Razor Vintage bracelet from the 50's...Now sold by STRAPCODE.. It was on E-Bay but then disapperaed for a couple of years and then a little different version showed up on Strap Code. The one on my Seiko has Curved end lugs but this one is straight bar Although, I did take off the end lug and fit it to the curved lugs on a Steinhart GMT...For the Glycine, I had to fabricate brass spacers of 1mm thickness because it's a 22 and the Glycine is a 24mm lug. I used a brass electrical wire connector and cut it as round as possible . It's a bit visible. I had to use 2 on one side and 1 on the other.
I tried it on a 24mm mesh and it looked nice but just not RIGHT on this watch. I think it looked too dressy.